Service Reference Guide, dx5150
361685-001
6–27
Removal and Replacement Procedures— Microtower (MT) Chassis
6.16 System Board
1. Prepare the computer for disassembly (
Section 6.1, “Preparation for Disassembly”
).
2. Remove the access panel and rotate the computer so the system board is parallel to the table
to make it easier to work on (
Section 6.3, “Access Panel”
).
3. Remove all PCI expansion cards (
Section 6.8.2, “PCI Expansion Card”
).
4. Remove the memory modules (
Section 6.7, “Memory Modules”
).
5. Remove the heatsink (
Section 6.14, “Heatsink”
).
6. Remove the processor (
Section 6.15, “Processor”
).
7. Disconnect all cables connected to the system board, noting their location for reinstallation.
8. Remove the eight screws that secure the system board to the chassis, then slide the board
toward the front of the computer until the rear I/O connectors clear the chassis.
Ä
CAUTION:
When installing a new system board, you must attach a new processor backing
plate to the system board. The heatsink will not attach properly if this plate is not installed.
Содержание dx5150
