HP DMX 400, Руководство оператора, Страница: 62 / 118

Creating Labels Using Internal Batch Software
52 DMX 400/430 Operator’s Manual
Copy Module: Copies graphic images and/or label
formats from one memory module to
another. Be certain that the write protect
switch is ‘on’ for the source module and
‘off’ for the destination module.
Metric: Each time the number 3 is pressed, the
screen will toggle between metric ‘No’
and metric ‘Yes’.
Print Test Label: Prints a Printhead Test Label and is used
as a relative gauge of Printhead condition
and wear.
System Test Label: Lists all current Printer settings and
checks both ROM and RAM. Prints a
Printhead test label after the system test.
Edit Module Name: This will allow you to change the name of
the module.
Reset Printer: This is the same as the <SOH #>
command in the standard printer mode. If
switch 7 is on then the internal batch will
take over.
Exit To RS-232C System: This is the same as turning Switch 7 ‘off’
and resetting the Printer. You can use the
<STX g> command to enter the Internal
Batch without using switch 7 in the rear
of the Printer.
Pack Module Data: All the label formats are stored in a 256K
flash module; therefore, only the entire
module can be cleared. For this reason,
the data will occasionally need to be
packed from time to time when the
memory becomes low.