4.
Remove the battery (see
Battery on page 28
).
5.
Remove the following components:
a.
Hard drive (see
Hard drive on page 29
)
b.
Memory/Mini PCI card module compartment cover (see
Memory module on page 31
)
c.
Optical drive (see
Optical drive on page 35
)
d.
Switch cover (see
Switch cover on page 37
)
e.
Keyboard (see
Keyboard on page 39
)
f.
Display assembly (see
Display assembly on page 41
)
g.
Base enclosure (see
Base enclosure on page 46
)
h.
Fan assembly (see
Fan assembly on page 49
)
Remove the heat sink:
1.
Remove the four Phillips PM2.5×6.0 screws
(1)
that secure the heat sink to the system board.
2.
Slide the heat sink
(2)
to the left until the right side of the heat sink clears the top cover.
NOTE
Due to the adhesive quality of the thermal paste located between the heat sink and
processor, it may be necessary to move the heat sink from side to side to detach the heat
sink from the processor.
ENWW
Component replacement procedures
51
Содержание DesignJet 500
Страница 1: ...HP 500 Notebook PC Maintenance and Service Guide ...
Страница 90: ...ENWW Phillips PM2 0 9 0 screw 85 ...
Страница 95: ...Where used 4 screws that secure the heat sink to the base enclosure 90 Chapter 8 Screw listing ENWW ...
Страница 104: ...Universal Serial Bus Pin Signal 1 5 VDC 2 Data 3 Data 4 Ground ENWW Universal Serial Bus 99 ...