HP DesignJet 500, Руководство по техническому обслуживанию и ремонту, Страница: 105 / 117

11 Power cord set requirements
The wide range input feature of the computer permits it to operate from any line voltage from 100 to 120
or 220 to 240 volts AC.
The 3-conductor power cord set included with the computer meets the requirements for use in the
country where the equipment is purchased.
Power cord sets for use in other countries must meet the requirements of the country where the computer
is used.
Requirements for all countries
The requirements listed below are applicable to all countries.
●
The length of the power cord set must be at least 1.5 m (5.0 ft) and a maximum of 2.0 m (6.5 ft).
●
All power cord sets must be approved by an acceptable accredited agency responsible for
evaluation in the country where the power cord set will be used.
●
The power cord sets must have a minimum current capacity of 10 amps and a nominal voltage
rating of 125 or 250 V AC, as required by each country’s power system.
●
The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard
Sheet C13 connector for mating with the appliance inlet on the back of the computer.
100 Chapter 11 Power cord set requirements ENWW