HP Brio BA200, Руководство пользователя

Страница: 39 / 96

33
Troubleshooting Help Zone
Hard Disk, DVD or CD-ROM Drive Test Error
Problem Possible cause To try and fix this ...
Power-On-Self-Test
displays hard disk, DVD or
CD-ROM drive test error The drive is incorrectly
configured in the PC’s
Setup program. Refer to
page 38 or page 39.
1 Switch the PC OFF then ON.
2 When the message Press F2 to Enter Setup appears,
press the
F2
key. Refer to page 22.
3 Check the drive is enabled and the correct type is selected.
Run DiagTools from the Brio Assist CD-ROM to test your hard drive or from your hard drive to test the
CD-ROM drive. Refer to page 20.
You may need to update
your PC’s Basic Input
Output System (BIOS). Create a floppy to update your PC’s BIOS. Refer to page 22.
More Advanced Troubleshooting
The drive cables are not
correctly connected. 1 Disconnect the power cord.
2 Remove the PC’s cover (refer to page 46).
3 Check the drive’s power and data cables are correctly
connected (refer to chapter 2).
4 Close the PC then switch it on and check it works.
The drive cable is not
working. 1 Disconnect the power cord.
2 Remove the PC’s cover (refer to page 46).
3 Replace the drive cable by a known working cable from the
same model of PC.
4 Close the PC then switch it on and check it works.
The drive is not working. 1 Disconnect the power cord.
2 Remove the PC’s cover (refer to page 46).
3 Replace the drive by a known working drive from the same
model of PC (refer to page 55 or page 57).
4 Close the PC then switch it on and check it works.
The system board is not
working. 1 Disconnect the power cord.
2 Remove the PC’s cover (refer to page 46).
3 Replace the system board by a known working board from
the same model of PC (refer to page 48).
4 Close the PC, reconnect the power cord and check that the
PC and drive work.
5 If the drive works, contact your authorized support provider
for further troubleshooting information.
You receive a S.M.A.R.T.
alert during the Power-On-
Self-Test. Defective drive IIIIm
m m
mppppoooort
rt rt
rtaaaannnntttt:
: :
: Carry out an immediate data backup, then contact HP
Support at
www.hp.com/go/briosupport
for a
replacement hard drive.
Refer to page 38 for more information on troubleshooting drives. There is also more DVD troubleshooting information in the
online HP Brio Center, under "Fix a Problem". If the problem persists, contact your authorized support provider
BrioGuide.book Page 33 Wednesday, September 1, 1999 2:37 PM