Non-Hot-Plug Procedures
Before removing or replacing non-hot-plug components, you must power down the HP PC Blade
Enclosure completely. Non-hot-plug components in the HP BladeSystem PC Blade Enclosure system
include:
●
Fan cage
●
Fan backplane assembly
●
Interconnect tray
●
Integrated Administrator module
●
Enclosure status assembly
●
Midplane assembly
Fan Cage
To remove the fan cage:
1.
Power down each HP Blade PC (
Powering Down a Blade PC on page 12
).
2.
Power down the enclosure. For more information see the
Powering Down the Enclosure
on page 10
.
3.
Disconnect all cables and power cords from the AC power source.
4.
Disconnect all cables and power cords from the enclosure rear panel.
5.
Remove all HP Blade PCs (
Removing a Blade PC on page 13
).
CAUTION:
Integrated Administrator security settings are assigned to HP PC Blade Enclosure
bays, not to HP Blade PCs. If HP Blade PCs change locations within the enclosure, Integrated
Administrator settings must also be adjusted to ensure accurate security. Refer to the
HP
Integrated Administrator User Guide
for more information on security settings.
6.
Remove both hot-plug power supplies (
Hot-Plug Power Supplies on page 8
).
7.
Remove the interconnect tray (
Removing the Interconnect Tray on page 15
).
8.
Remove the enclosure from the rack (
Removing the HP PC Blade Enclosure from the Rack
on page 16
).
9.
Place the enclosure on a level, non-conductive surface.
10.
Open the access door
(1)
(
Opening the Access Door on page 17
).
11.
Press the fan cage release latch
(2)
.
12.
Pull the fan cage out of the enclosure until it locks in the open position
(3)
.
13.
Open the latches on the cable connector
(4)
.
14.
Disconnect the fan cable from the midplane (power board)
(5)
.
15.
Press the fan cage removal latch on top of the fan cage
(6)
.
18
Chapter 3 Removal and Replacement Procedures
Содержание BladeSystem bc2200 - Blade PC
Страница 1: ...Service Reference Guide HP BladeSystem PC Blade Enclosure G2 Assemblies ...
Страница 6: ...vi ...
