Removing the HP PC Blade Enclosure from the Rack
WARNING!
Rack rails do not have safety latches. Be sure that at least two persons are available to
prevent the enclosure from falling and causing bodily harm when removing it from the rack.
To remove the HP PC Blade Enclosure from the rack:
1.
Power down each HP Blade PC (
Powering Down a Blade PC on page 12
).
2.
Power down the enclosure (
Powering Down the Enclosure on page 10
).
3.
Disconnect all cables and power cords from the AC power source.
4.
Disconnect all cables and power cords from the enclosure rear panel.
5.
Remove all HP Blade PCs and HP Blade PC blank bezels (
Removing an HP Blade PC Blank
Bezel on page 14
).
6.
Remove both hot-plug power supplies (
Hot-Plug Power Supplies on page 8
).
7.
Remove the interconnect tray (
Removing the Interconnect Tray on page 15
).
8.
Loosen the thumbscrews on the front of the enclosure
(1)
.
9.
Remove the enclosure from the rack
(2)
.
Figure 3-10
Removing the enclosure from the rack
NOTE:
Pull the enclosure out using the handles. Pulling the enclosure by the thumbscrews
damages the thumbscrews.
Reverse the previous steps to install the enclosure into the rack.
16
Chapter 3 Removal and Replacement Procedures
Содержание BladeSystem bc2200 - Blade PC
Страница 1: ...Service Reference Guide HP BladeSystem PC Blade Enclosure G2 Assemblies ...
Страница 6: ...vi ...
