HP Barney Oliver, Руководство пользователя

Страница: 4 / 33

Description
The Barney Oliver Audio Amplifier
SPECIFICATIONS
OUTPUT PER CHANNEL
SPEAKER Z
CONTINUOUS* AUDIO PEAK
16
�36 W
�90W
8
�50 W
�160 W
4
**
�80W
HARMONIC DISTORTION
<
0.01 %, 2 mw to max. power, all freqs.
HUM AND NOISE
Power Amplifier:
100 db below max. output
t
Phono Preamp:
84 db below one volt output
INPUT VOLTAGE FOR FUll OUTPUT
Tuner, Tape, Aux
1, Aux 2:
�
1.0 volt rms
Phono: �
5 mv rms
INPUT IMPEDANCE
Tuner, Tape, Aux 1,
Aux 2: 100
K n
Phono:
Optimized for SHURE V-15 Type II
Pickup.
CONTROLS
INPUT: TUNER, TAPE, PHONO, AUX 1,
AUX 2.
MODE:
STEREO - D IR(ect), REV(erse), L, R
MONO - DUAL, L, R
*Both channels operating simultaneously at
maximum output.
**Continuous high power operation at less
than
8 n
not recommended. See instruction
manual.
t Hum pickup by phono cartridge may cause
this figure to be exceeded.
1-2
FREQUENCY RESPONSE
+15
-15
CONTROLS (Cont'd.)
FILTER: Controls active h.f roll-off filter
>
18 dB/octave with corner at 5, 8, 10 or
20 kHz. Includes 30 dB notch at 10 kHz
in 5 and 8 kHz positions.
VOLUME: Dual precision attenuator, 60 dB
range, 2 dB steps. Eliminates need for
balance control.
BASS: FLAT, BOOST
Response:
RIAA,
+
6 dB, - 6 dB
SIZE:
16.72" (425 mm) wide, 5.0" (127 mm) high,
10.93" (278 mm) deep behind panel.
WEIG HT
Approximately 20 pounds net without case.
POWER REQUIREMENTS
115 or 230 V.A.C.
±
10%, 50-60 Hz, 20 W
standby power, 135 W at full output into
16
n
(both channels).