HP Aruba 8325 Series, Руководство по установке и началу работы

Страница: 43 / 70

Chapter 3 Installing the switch 43
If the switch detects a 10GBase-T (JL563A) transceiver in any port that does not support it, the
show interface
brief
command will list an
Incompatible interface
for that port.
Installing transceivers:
Hold the transceiver by its sides and gently insert it into either of the slots on the switch until it clicks into place.
When a transceiver is inserted the switch authenticates it. This can take 1-3 seconds, with the worst case being 5
seconds.
Figure 27: Installing a transceiver
Removing transceivers:
Depending on the transceiver, it will have either of three different release mechanisms:
• A plastic tab on the bottom of the transceiver
• A plastic collar around the transceiver
• A wire bail
To remove the transceivers that have the plastic tab or plastic collar, push the tab or collar toward the switch until
the transceiver releases from the switch (it will move outward slightly), then pull it from the slot.
To remove the transceivers that have the wire bail, lower the bail until it is approximately horizontal, and then using
the bail, pull the transceiver from the slot.
The switch does not support 10GBase-T (JL563A) transceivers in ports 3, 6, 9, 12, 15, 18, and 19
through 48. 10GBase-T support for ports 13-14, and 16-17 was added with software release 10.03.
The fiber Aruba transceivers are Class 1 laser devices. Avoid direct eye exposure to the beam coming
from the transmit port.
Refer to Table 6 , footnote 3, for ports that support 10GBase-T transceivers.