HP Aruba 8325 Series Скачать руководство пользователя

Страница: 44 / 70

Aruba 8325 Switch Installation and Getting Started Guide

8. Connect the switch to a power source

If a power supply is not already installed in the switch, install at least one power supply. (See

“2. Install power

supplies”

.) The Aruba 8325 switch uses any of the following power supplies:

•

Aruba 8325 650W 100-240VAC FB PSU (JL632A)

•

Aruba 8325 650W 100-240VAC BF PSU (JL633A)

•

Aruba 8325 850W 48VDC FB PSU (JL861A)

•

Aruba 8325 850W 48VDC BF PSU (JL862A)

Connect an AC power cord or DC power cable to the switch and to an AC or DC power source.

Check the LEDs. See

“Chassis LEDs on the front of the switch”

9. Set up for initial configuration

You can perform the initial configuration of the switch using one of these methods:

•

Using Zero Touch Provisioning (ZTP):

Use ZTP to configure a switch automatically from a remote server.

The switch must be in the factory default configuration. If ZTP is to be used, your network administrator or
installation site coordinator must provide an RJ-45 cable connected to the appropriate network. Connect the
switch to the network using the RJ-45 out-of-band management port and power on the switch (or power off,
then power on the switch). The ZTP operation is attempted for the first 10 minutes after the switch is powered
on. For more information about ZTP, see the

Fundamentals Guide

for your switch and software release.

•

Using the Aruba CX mobile app:

The Aruba CX mobile app can connect to the switch through the USB

Bluetooth adapter. For information about using the Aruba CX mobile app to configure the switch, see the

Fundamentals Guide

for your switch and software release.

•

Using an out-of-band serial console:

Use a workstation configured with suitable VT-100 terminal emulation

software and connect the workstation to the switch’s RJ-45 Console Port. A DB9-to-RJ-45 console cable can
be ordered from HPE: JL448A, Aruba X2C2 RJ45 to DB9 Console Cable. For more information about this
method see

“Initial configuration with an out-of-band serial connection”

“.

•

Using connections to the out-of-band dedicated management network:

Use a workstation configured with

suitable VT-100 terminal emulation software and SSH software. Connect the workstation and the switch to the
same management network. Connect the switch to the network using the RJ-45 out-of-band management port.
For more information about using this method, see the

Fundamentals Guide

for your switch and software

release. The switch can simultaneously support one console session through the console port and multiple
network SSH sessions through the management port.

10. Connect the network cables

Connect the network cables, described under “Cabling Infrastructure” (

1. Prepare the installation site

), from the

network devices or your patch panels to the RJ-45 out-of-band management port on the switch or to any
transceivers you have installed in the switch.

Using the RJ-45 out-of-band management port

If you plan to manage the switch from a dedicated management network, connect an RJ-45 network cable from the
management network to the Mgmt port. The Mgmt port supports 10, 100, and 1000 Mbps connections.

To connect:
Push the RJ-45 plug into the RJ-45 port until the tab on the plug clicks into place. When power is on for the switch

One power supply provides power to operate the switch. Installing a second power supply can provide
power to the switch in case the initial power supply fails. If the power supplies are plugged into different
power sources, redundant power can be supplied in case of loss of one of the power sources.