7.
Remove the system board
(3)
from the system board frame by sliding it forward.
Reverse the preceding procedure to install the system board.
RJ-11 connector cable
NOTE:
The RJ-11 connector cable is included in the Cables Kit, spare part number 452198-001.
Before removing the RJ-11 connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 47
).
5.
Remove the following components:
a.
Hard drive (see
Hard drive on page 51
)
b.
Optical drive (see
Optical drive on page 54
)
c.
Keyboard (see
Keyboard on page 58
)
d.
Fan (see
Fan on page 63
)
e.
Heat sink (see
Heat sink on page 64
)
f.
Switch cover (see
Switch cover on page 75
)
g.
TouchPad (see
TouchPad on page 70
)
h.
Display assembly (see
Display assembly on page 79
)
i.
Top cover (see
Top cover on page 84
)
94 Chapter 4 Removal and replacement procedures
Содержание 8510p - Compaq Business Notebook
