12
otherwise it will cause deviation. The Meter can only measure one
conductor at a time, to measure more than one conductor at a time will
cause deviation.
4. The double display shows the AC current True RMS value and AC
voltage True RMS value.
5. Press
MAX/
▲
, the LCD displays MAX, it starts recording the maximum
AC current True RMS value.
Press
MAX
/▲
again to show the present AC True RMS value.
6. Press
MIN
/▼
,
the LCD displays MAX, it starts recording the minimum
AC current True RMS value. Press
MAX
/▲
, again to show the present AC
current True RMS value.
7. The display shows
9999
when the current of the tested conductor is
higher than 1000A rms.
Note
●
When the measurement has been completed, disconnect the connection
between the conductor under test and the jaw, and remove the conductor
away from the transformer jaw of the Meter.
C. Active Power (main display) + Phase Angle (secondary display)
Measurement
The active power ranges are:40A, 100A, 400A and 1000A
The phase angle ranges are: 0° ~360°
Warning
To avoid damages to the Meter or harms to you, do you measure
higher than AC voltage 600 v.r.s. and AC current 1000A v.r.s.
To measure active power + phase angle, connect the Meter as follows:
1. Press the
MENU
to select Active power (main display) + Phase angle
(secondary display) range.
2. Press the lever to open the transformer jaw, and clamp them to the
corresponding phase of tested conductor. If user needs to measure any
phase of
the 3 phase, then clamp them to that phase’s conductor.
3. Connecting method (see figure 6, 7, 8):
●
When measuring 3 phase 4 wires, connect the
Meter as figure 6.
