HP 84125C, Руководство пользователя

Страница: 80 / 101

4. Shut down Windows NT and turn o the computer .
5. Remove the computer cover and install the GPIB interface card. If
possible , avoid using the rst or last slot as it is dicult to connect
the GPIB interface cable with the card in either of these locations .
6. Turn on the computer and start Windows NT .
Software Setup
After installation of the NI-488.2 software , the windows group
NI-488.2 GPIB Software will be created. Prior to verifying proper
operation of the hardware and software installation, you will need to
perform the following steps .
1. From the Windows NT Start menu, select Settings , Control P anel,
then double-click on the GPIB icon.
2. In the GPIB Conguration window , with the GPIB0 board
highlighted, click on the Congure button.
3. In the GPIB0 (A T-GPIB/TNT) window , click on the DMA Channel
drop-down list box and set the DMA to the value set on the card in
step 1 of \Hardware Setup and Installation".
4. Set the Base I/O A ddress and IRQ to the same values set on the
card in steps 2 and 3 of \Hardware Setup and Installation".
5. Click on the OK button.
6. Click on the OK button in the GPIB Conguration window to exit
the GPIB application.
Hardware V erication A T-GPIB/TNT
It is important to test your hardware conguration before attempting
to use the A T-GPIB interface . Use the following procedure to verify
correct operation.
1. From the Windows NT Start menu, select Programs , NI-488.2M
for Windows NT , Diagnostic.
2. In the Diagnostic window , click on the T est All button.
3. When the test is complete , click on the Exit button to exit the
software diagnostic test.
Using the HP 84125C Utility 7-9