13.
Remove the three remaining screws that secure the system board to the chassis.
Figure 6-36
Removing the system board
14.
Slide system board toward the front of the unit until the rear connectors are clear of their slots in
the chassis.
15.
Lift the rear of the system board until it clears the chassis, and then remove the system board
from the chassis.
To install the system board, reverse the removal procedure.
NOTE:
When replacing the system board, you must also change the chassis serial number in the
BIOS.
Rear Fan
The rear fan is secured to the rear right corner of the chassis. You must remove the system board
before you can remove the rear fan.
1.
Prepare the computer for disassembly (
Preparation for Disassembly on page 30
).
2.
Remove the computer access panel (
Computer Access Panel on page 38
).
3.
Remove the front bezel (
Front Bezel on page 39
).
4.
Remove the optical drive (
Removing the Existing Optical Drive on page 46
).
5.
Remove the memory modules (
Installing Additional Memory on page 41
).
6.
Remove the front fan (
Front Fan on page 55
).
7.
Remove the hard drive (
Hard Drive on page 49
).
8.
Remove the heat sink (
Heat sink on page 58
).
62
Chapter 6 Removal and Replacement Procedures
Содержание 8000f - Elite Ultra-slim Desktop PC
Страница 1: ...Maintenance and Service Guide HP Compaq 8000f Elite Business PC Ultra slim Desktop ...
Страница 4: ...iv About This Book ...
Страница 10: ...x ...
