22
Figure 24
Installing a power supply (for the 96G model/96G TAA model)
Removing a power supply
CAUTION:
•
If the switch has two power supplies, removing one power supply does not affect the operation of the
switch. If the switch has only one power supply, removing the power supply powers off the switch.
•
The power cord color code scheme in
Figure 25
is for illustration only. The cable delivered for your
country or region might use a different color scheme. When you connect the power cord, always
identify the polarity symbol on its wires.
To remove a power supply:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Remove the power cord from the power supply.
{
If the power supply is AC powered, directly unplug the power cord.
{
If the power supply is DC powered, squeeze the tabs on the power cord connector with your
thumb and forefinger and pull the connector out, as shown in
Figure 25
.
3.
Hold the handle on the power supply with one hand, pivot the latch on the power supply with
your thumb, and pull the power supply part way out of the slot, as shown in
Figure 26
and
Figure 27
.
4.
Supporting the power supply bottom with one hand, slowly pull the power supply out with the
other hand. Put the removed power supply in an antistatic bag for future use.
5.
If no power supply is to be installed, install the power filler module.
