
Model
nstallation
SECTION
INSTALLATION
INTRODUCTION
2-2. This section provides information for inspection, installation, and prepration for use of
the
Signature Analyzer.
INSPECTION
2-4. Inspect the shipping container for damage. If the shipping container or cushioning
material
i s
damaged, it should be kept until the contents of the shipment have been checked
for completeness and the instrument has been checked mechanically and electrically. The
contents of the shipment should be as shown in Figure
procedures for checking electrical
performance are given in Section IV. If the contents are incomplete, if there i s mechanical
damage or defect, or if the
does not pass the performance tests, notify the nearest
Packard office. If the shipping container is damaged, or the cushioning material shows signs
of stress, notify the carrier as well as the Hewlett-Packard office. Keep the shipping materials
for carrier's inspection. The HP office will arrange for repair or replacement at HP option with-
out waiting for claim settlement.
2-5. PREPARATION FOR USE
2-6. Power Requirements
2-7. The
requires a power source as shown in Section
I,
Specifications.
2-8. Line Voltage Selection
2-9. Changing the
power sourcevoltagesetting requires the
cabinet to beopened.
Instructions for changing the line voltage setting are given in Section
2-10. Line Voltage Label
2-11. The original line voltage setting for each
as manufactured is printed on a label on
the back panel of each
Check this label and compare the voltage (100,120,220, or
with your local line voltage supply. If you do not have the correct line voltage for your
notify a qualified technician and refer to Section
of this manual.
2-12. Power Cable
2-13. The
is shipped with a three-wire power cable. When the cable is connected to an
appropriate ac power source, this cable grounds internal "grounds" in the
and the two
exposed screws on the rear panel heat sink. The type of power cable plug shipped with each
instrument depends on the country of destination. Refer to Figure
for the part numbers
of the power cable and plug configurations available.
Содержание 5004A
