P/N 480-0005-00-15
8-19
Chapter 8: Diagnostics/Maintenance
Move card location or change card type
To make changes to the card location or the card types in your Tenor CMS, you must perform software as well
as hardware procedures. See below.
1. Initiate a CLI session. See
Chapter 4: Getting Started with Command Line Interface (CLI)
for more infor-
mation.
2. After the login prompt, at the initial
prompt, access the slot in which the card is located (i.e., type
slot 5
).
The prompt for that slot will be displayed.
3. Type
remove
. The card will be removed from the database.
4. Power down the chassis and unplug the power cord from the unit to prevent any accidental power cycling
of the CMS.
5. Follow steps 1-7 only, as outlined in the section titled
Replace WAN/System Controller/CPU cards of iden-
tical type
in this chapter.
6. Physically remove the Rear Transition Module (RTM), if a WAN or a DS1 card slot is being changed or
relocated. For more information about rear transition module cards, see
Chapter 2: Hardware Components
and
Card Maintenance/Replacement
earlier in this chapter.
CAUTION:
Front application T1, E1 of DS1 cards must always be matched with their appropriate rear
transition modules. DSP cards must never have a Rear Transition Module (RTM) installed
behind them in the same slot number.
7. With a grounded wrist strap, install the new card or install the card in a new location, and only when
required, install the matching rear transition card. This may require moving the blank face plates. Re-
tighten handle lock down screws with a #1 Phillips screwdriver.
8. Replace the power cord back into the rear of the chassis and turn on the power switch. The Tenor CMS
will auto detect the new cards and/or locations.
NOTE:
Depending upon your network, additional configuration may be required. Consult the
CMS CLI
Guide
for more information.
Содержание 480-0005-00-15
Страница 8: ...P N 480 0005 00 15 1 About this Guide ...
Страница 161: ...A 1 P N 480 0005 00 15 Appendix A Getting Acquainted with Tenor CMS in the VoIP Network ...
Страница 168: ...B 1 P N 480 0005 00 15 Appendix B Specifications Approvals ...
Страница 171: ...B 4 P N 480 0005 00 15 Appendix B Specifications Approvals Storage Temperature 14 to 140 F 10 to 60 C ...
