HP 2520-24, Руководство по настройке

Страница: 46 / 110

2-4
IPv6 Management Features
IPv6 Telnet Operation
Figure 2-3. Example of Clearing the IPv6 Neighbors Cache
IPv6 Telnet Operation
This section describes Telnet operation for IPv6 on the switch. For IPv4 Telnet
operation, refer to the
Management and Configuration Guide for your
switch.
Outbound Telnet to Another Device
Syntax: clear ipv6 neighbors
Executed at the global config level, this command removes all
non-local IPv6 neighbor addresses and corresponding MAC
addresses from the neighbor cache. (Local IPv6 addresses, that
is, IPv6 addresses configured on the VLAN interface for the
switch on which the command is executed, are not removed.)
Removed addresses are listed in the command output.
HP Switch(config)# clear ipv6 neighbors
HP Switch(config)# show ipv6 neighbors
HP Switch# show ipv6 neighbors
IPv6 ND Cache Entries
IPv6 Address MAC Address State Type Port
--------------------------------------- ------------- ----- ------- ----
fe80::213:c4ff:fedd:14b0 000000-000000 INCMP dynamic
For an active-route next-hop, the MAC address and
source port data is removed, and the State is set to
“Incomplete” until the route is refreshed in the
neighbor cache.
Syntax: telnet < link-local-addr >%vlan< vid > [oobm]
telnet < global-unicast-addr > [oobm]