20
Support and troubleshooting
The following table lists possible problems, the possible cause or each problem, and the recommended
solutions.
Table 4-2:
Solving common problems
Problem
Possible cause
Solution
Screen is blank or
video is flashing.
Power cord is disconnected.
Connect the power cord.
Monitor is off.
Power the power button.
NOTE: If pressing the Power
button has no effect, press
and hold the power button
for 10 seconds to disable the
Power button lockout
feature.
Video cable is improperly connected.
Connect the video cable
properly.
System is in Sleep mode.
Press any key on the
keyboard or move the
mouse to exit Sleep mode.
Video card is incompatible.
Open the OSD menu and
select the Input Control
menu. Set Auto-Switch Input
to Off and manually select
the input
Image appears
blurred,
indistinct, or too
dark.
Brightness is too low.
Open the OSD menu and
select
Brightness
to adjust
the brightness scale as
needed.
Check Video
Cable
is displayed
on screen.
Monitor video cable is disconnected.
Connect the appropriate
video signal cable between
the computer and monitor.
Be sure that the computer
power is off while you
connect the video cable.
Input Signal Out
of Range
is
displayed on
screen.
Video resolution and/or refresh rate are set higher
than what the monitor supports.
Change the settings to a
supported setting.
The monitor is
off, but it did not
seem to enter
into Sleep mode.
The monitor’s power saving control is disabled.
Open the OSD menu and
select
Power Control >
Auto-Sleep Mode
and set
auto-sleep to
On
.
On-Screen Menus
are Locked
is
displayed.
The monitor’s OSD lock function is enabled.
Press and hold the
Menu
button on the front bezel to
10 seconds to disable the
Содержание 24fh
Страница 1: ...Maintenance and Service Guide 24fh model 27fh model ...
Страница 11: ...7 Safety label ...
Страница 19: ...15 Step 5 Strip the screws 4pcs Strip the other screws 8pcs from the M B ...
