Optical drive connector board
Description
Spare part number
Optical drive connector board
924990-001
Optical drive cable
924926-001
Before removing the optical drive connector board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4.
Remove the battery (see
).
5.
Remove the optical drive (see
), if installed.
6.
Remove the bottom cover (see
To remove the optical drive connector board:
1.
Disconnect the cable from the optical drive connector board (1).
2.
Remove the Phillips PM2.0×2.0 screw (2) that secures the optical drive connector board to the computer.
3.
Rotate the connector side of the board upward, and then pull the board up and out of the computer (3).
Reverse this procedure to install the optical drive board connector.
52
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Содержание 15-bs0 Series
