2
Welcome to Hougen.
2
HMD130 Exploded View
8
Important Safety Instructions
3-4
Parts List
9
Safety Switch Indicator Light
4
Motor Diagram & Part List
10
Operating Instructions
5
Rotaloc Series of Cutters
11
Rotaloc Plus Cutter Installation
6
Limited Warranty Information
11
Control Panel Diagram
7
Factory Authorized Warranty Repair Centers
12
HOUGEN
®
PORTABLE MAGNETIC DRILL
moDel HmD130 serIes
Welcome to Hougen
Congratulations on your purchase of the Hougen
®
Portable Magnetic Drill. Your model is designed to produce superior holes quickly and
efficiently. Through constant innovation and development, Hougen is committed to provide you with hole producing tools and products to
help you be more productive.
Before attempting to operate your new Portable Magnetic Drill, please read all instructions first. These include the Operator’s Manual and
Warning Label on the unit itself. With proper use, care, and maintenance, your model will provide you with years of effective hole drilling
performance. Once again, thank you for selecting our product and welcome to Hougen.
Refer to the Serial/Part number Label on your housing to direct you
to the correct breakdown.
Part Number
0130101 HMD130 115V
Specifications
Serial Number/
Part Number Label
Cutter Type........................RotaLoc Plus
Hole Capacity....................1/2" to 1-3/8" (12mm-35mm)
Depth of Cut......................1" (25mm)
Motor.................................450 RPM, 8A
Net Weight........................23.4 lbs. (10.6 kg)
Noise Specifications
Weighted Sound Pressure....................... LpA=88.9dB(A)
Weighted Sound Pressure Uncertainty.....KpA=3dB(A)
Weighted Sound Power............................LwA=101.9dB(A)
Weighted Sound Power Uncertainty.........KwA=101.9dB(A)
INDEX
1. Open shipping carton and remove the literature and
hardware packages.
2. Read and Follow All Instructions before attempting
to operate your new Magnetic Drill.
3. Complete and mail the Product Registration Card now.
It is important that Hougen Manufacturing, Inc. have a
record of product ownership.
4. Open hardware package and check contents.
17059 Safety Strap
08511 Feed handle
17021 Oval Knob
11741 RotaMagic
11746 Slick-Stik
5. Using the rear handle of Magnetic Drill, lift unit out of the
shipping case.
6. Remove all packing and securing material from the drill
unit.
7. Screw the Knob into the Feed Handle and then screw
Handle into the Hub Assembly. Do not over tighten
or may strip the knobs.
8. Your Magnetic Drill was factory adjusted prior to shipping.
Check to make sure that all motor mount screws and
magnet mounting screws are snug and have not vibrated
loose in transit.
9. Your new Low profile Magnetic Drill uses Hougen
RotaLoc Plus™ Cutters.
Reread Safety Warnings listed in the Operator’s Manual
and on the drill unit to avoid injury. Follow operating
procedures.
UNPACKING YOUR NEW DRILL
Approved Duty Cycle Rated: 2 minutes "ON", 3 Minutes "OFF"
