Hotpoint WD640, Инструкция по эксплуатации

Страница: 6 / 16

PROGRESS INDICATOR lights :
These will light up to indicate the
progress of the selected
programme.
When the programme is started the light corresponding
to the first cycle is lit and as the programme
progresses, successive lights will come on until the
programme finishes.
During a wash programme the display will show the
time remaining to the end of the programme.
OPTION buttons / lights :
When an option is selected, the
corresponding light is illuminated.
●
If the option selected is incompatible with the
programme set, the button will flash and the option
will not be enabled.
●
If you set an option that is incompatible with an
option selected previously, only the last option
selected will be enabled.
5
DOOR LOCKED light :
This light will come on two seconds after the
Start/Cancel button has been pressed and will stay lit
throughout the programme.
If this light is on, the appliance door is locked to
prevent it from being opened accidentally; to avoid
any damage. Wait for the light to go out before you
open the door.
! The DOOR LOCKED indicator light will flash and
‘door’ will appear in the display to indicate the door
has not been closed properly, and the selected
programme will not start. Push the door shut until you
hear the catch click, the DOOR LOCKED light will
stop flashing and the selected programme will start.
DISPLAY
The display shows either the amount of time delay
remaining until the start of a programme, or gives an
indication of the amount of time left for a programme in
progress.
The delay time is displayed in hours and counts down
each hour.
The time to end is displayed in hours and minutes and
counts down each minute. The approximate
programme times are dependant on the temperature
and pressure of the incoming water supply, the
option(s) selected and the load being washed. They
may therefore change during the fill stages of each
programme to take into account the extra heating or fill
time required.
The colons between the hours and minutes in the
display flash to show that the time is counting down.
The display also shows if there is a problem with your
machine, if this occurs the display will show F followed
by a fault code number:
- H20 A problem with the water supply.
Check that both water supply taps are
turned on and working.
- door The door is not closed ( as above ).
Push the door shut until you hear the catch
click.
- F000 Indicates a machine fault.
Please note the code and contact the
Service Centre (
see Service ).
GB GB
Washer Dryer Description