Hotpoint SI E40 BA1 UK, Руководство по эксплуатации

Страница: 9 / 16

99
en
Before filling the iron with water, make sure that
the iron is switched-off and disconnected from the
electrical socket.
1. Set the steam regulator (3) to Off.
2. Tilt the iron in such a position to make water
entrance easier.
3. Open the lid of the filler hole (13) and fill the water
reservoir using the water measurer supplied with
the iron. Never fill the water reservoir above the
maximum water level (10).
4. Close the lid of the filling hole.
Never add any perfume, vinegar, starch,
scale-removing agents, ironing products or
other chemicals in the water reservoir - unless
recommended by Hotpoint. Never use
contaminated water.
USING THE IRON
In order to make reading this instructions manual
easier and identify the model of your Quick Perfect
iron, refer to the graphics on page II .
Your iron is supplied with Power Off System
safety device which automatically switches
the iron off when it is left unattended or tips over
and ensures maximum safety.
Selecting the temperature
and adjusting the steam (B
1
)
LCD
1. Connect the plug of the appliance into a
grounded socket (220/240V).
2. The LCD (14) lights up in red and starts flashing
to indicate that the iron is reaching the set
temperature.
3. Use the temperature b/- (4a) to select
the desired temperature. Every time you press
one of the two buttons, the display lights up and
starts flashing to indicate that the steam iron is
reaching the selected temperature.
4. When the iron reaches the set temperature, the
LCD lights up in green and the set temperature
is shown in fixed mode to indicate that the iron
is ready for use.
5. Make sure to check the garment label in order
to identify the fabric type. In case of doubts, it
is recommended not to the use spray function
and iron a hidden corner in order to determine
the most appropriate temperature and avoid
damaging the fabric. In case of very delicate
fabrics, such as silk, wool, and synthetic
materials, iron the garment inside out to prevent
shiny marks. Start ironing the garments that
require a lower temperature, such as synthetic
fabrics.
Fabrics with this symbol on the label must
not be ironed.
GARMENT
LABEL
FABRIC TYPE TEMPERATURE
INDICATION
STEAM
INDICATION
synthetic
silk
mixed cotton
wool
mixed wool
cotton
linen
jeans
6. Select the steam level with the steam regulator
(3) or move it to Off to iron without steam. When
steam ironing, make sure that the water level in
the reservoir is at least ¼.
Selecting the temperature
and adjusting the steam (B
2
)
1. Connect the plug of the appliance into a
grounded socket (220/240V).
2. Use the temperature control (4b) to select the
desired temperature. If you go from a lower
temperature to a higher temperature, the
temperature indicator light (4c) light up until the
selected temperature is reached.
3. When the iron reaches the set temperature, an
acoustic signal is emitted and the temperature
indicator light goes off.
4. We recommend to check the garment label
in order to identify the fabric type. In case of
doubts, it is recommended not to use the spray
function and iron a hidden corner in order to
determine the most appropriate temperature
and avoid damaging the fabric. In case of very
delicate fabrics, such as silk, wool, and synthetic
materials, iron the garment inside out to prevent
shiny marks. Start ironing the garments that
require a lower temperature, such as synthetic
fabrics.