RANGE
1.
Remove the broiler drawer (see page 30).
2. Use a 3/16” open-end or socket wrench to back
out both rear leveling legs approximately two turns.
3. Use a 1%” open-end or adjustable wrench to
back out the front leveling legs two turns.
INSTALLING
WARNING:
Range must be secured with the Anti-Tip
device supplied.
Unless properly installed, the range could be
tipped by an adult or a child standing, sitting
or leaning on an open door or drawer.
After installing the Anti-Tip device, make
sure it is in place by carefully attempting to tilt
the range forward.
●
This range has been designed to meet all
recognized industry tip standards for all
normal conditions.
●
The use of this device does not preclude
tipping of the range when not properly installed.
●
If the Anti-Tip device supplied with the
range does not fit this application, use the
universal Anti-Tip device WB02X7909.
4.
With the oven shelves in the oven, position the
range where it will be installed.
5. Check for levelness by placing a spirit level or
a partially filled cup of water on one of the oven
shelves. If using a spirit level, take two
with the level placed diagonally first in one
direction and then the other.
6. Adjust the leveling legs until the range is level.
7.
After the range is level, slide the range away
from the wall so that the Anti-Tip device can be
installed.
(continued next page)
1.
Mark the wall where the RIGHT EDGE of the
range is to be located. Be sure to allow for the
countertop overhang if you intend to install the
range next to cabinets.
2. Locate the outside edge of the device
toward the center of the range from the marked
edge of the range.
3.
Using the device as a template, mark the
position of the hole for the screw.
4.
For wood construction,
drill a pilot hole at
an angle of 20 degrees from the horizontal. A nail
or awl may be used if a drill is not available.
Mount the Anti-Tip device with the screw provided.
For cement or concrete construction,
you
will
need a 1/4” x
lag bolt and a
1/2”
sleeve anchor, which are not provided. Drill the
recommended size hole for the hardware.
Install the sleeve anchor into the drilled hole and
then install the lag bolt through the device. The
bolts must be properly tightened as recommended
for the hardware.
