Using Your Oven
Lighting Instructions for
Standing Pilot Model
RGB524PN
This range has a standing oven pilot
that must be lit initially.
To light the oven pilot:
1. Be sure OVEN CONTROL
knob is in the OFF position.
2. Open the broiler drawer and pull
the drawer down flat. Put the broiler
pan in the lowest position and slide
the drawer back into the range. This
will make it easier for you to reach
inside the broiler compartment.
4. Using a long match or match
holder, reach in and light the oven
pilot.
To light the oven burner:
Turn the OVEN CONTROL knob
to the desired temperature. The
burner should light within 60
seconds.
Proper flame configuration:
While using the oven burner,
visually check the burner flame in
the broiler compartment. If flame
does not burn as described under
Oven Burner Air Adjustment Shutter
on page 21, adjust the flame
following the directions on that page.
Power failure? An electrical power
failure will not affect a lighted
standing oven pilot.
Lighting Instructions for
Electric Ignition Models
RGB524EN, RGS525GEN,
RGB528EN, RGB528GEN,
RGB628GEN
The oven burner on these ranges is
lighted by electric ignition.
To light the burner, turn the
OVEN CONTROL knob to the
desired temperature. The burner
should light within 60 seconds.
CAUTION: DO
MAKE ANY
ATTEMPT
OPERATE THE
ELECTRIC IGNITION OVEN
DURING AN
POWER FAILURE. The oven
cannot be lit during a power failure.
Gas will not flow unless the glow
bar is hot.
If the oven is in use when a power
failure occurs, the oven burner
shuts off and cannot be
until
power is restored.
3. Find the oven pilot port at the
back of the broiler compartment.
The long tube, running from front
to back, is the oven burner. The
pilot port is at the back, about one
inch below the burner.
10
