GENERAL
●
See Dimensions and Clearances on page 23
for all rough-in and
dimensions. These
dimensions must be met
safe use of your
range. The location of the electrical outlet and
pipe opening shown on page
may be adjusted
to meet specific requirements.
●
The range may be placed with O“ clearance
(flush) at the back wall and side walls of the range.
LOCATION
Do not locate the range where it may be subject
to strong drafts. Any openings in the floor or wall
behind the range should be sealed. Make sure the
openings around the base of the range that supply
fresh air for combustion and ventilation are not
obstructed by carpeting or woodwork.
PROTECT YOUR FLOOR
Your range, like many other household items, is
heavy and can settle into soft floor coverings such
as cushioned vinyl or carpeting. Use care when
moving the range on this type of flooring. It is
recommended that the following simple and
inexpensive instructions be followed to protect
your floor.
The range should be installed on a sheet of
plywood
-
(or similar material) as follows:
the
at the front of the
the area
that the range will rest on should be built up with
plywood to the same level or higher than the floor
covering. This will allow the range to be moved
for cleaning or servicing.
MODEL AND SERIAL NUMBER LOCATION
The model and serial numbers are on a label
located on the front frame of the range, behind
either the oven door or the front of the broiler
drawer.
TOOLS YOU WILL NEED
●
Phillips and flat-blade screwdrivers (one flat
blade with a shaft diameter of less than 3/16”)
Pencil and ruler
. Two pipe wrenches (one for backup)
. 1%” open-end or adjustable wrench
●
3/16” open-end or socket wrench
. Nut driver
In addition, for LP gas conversion, you will need:
. 5/16” open-end wrench
●
1/2” open-end wrench
ADDITIONAL MATERIALS YOU MAY NEED
.
Gas line shutoff valve
. Pipe joint sealant or pipe thread tape with
Teflon* that resists action of natural and LP gases
. Flexible metal appliance connector (1/2” I.D.).
A 5-foot length is recommended for ease of
installation but other lengths are acceptable.
●
Flare union adapter for connection to gas supply
line (3/4” or 1/2” NPT x 1/2” I. D.)
●
Flare union adapter for connection to pressure
regulator on range (1/2” NPT x 1/2” I. D.)
*Teflon: Registered trademark of DuPont
PREPARATION
Remove all tape and packaging. Be sure to
remove plastic film that covers some chrome parts
(around oven doors, side trim).
. Take the accessory pack out of the oven.
Check to be sure that no range parts have come
loose during shipping.
25
