15 of 18
Indesit
Company
Service Manual UK
English
E.
Door Seals
There is a moulding at the rear of the door seal that locates into a groove in the door liner to secure it.
1.
To remove, ease the seal away from the door liner at one of the corners then work around the door to
release completely.
2.
When refitting, if the seal is a tight fit into the liner, the liner must be supported to prevent any damage.
F:
Freezer Fan Housing, Rear Duct & Fan Motor Assembly
1.
Remove 2 screws from the Upper Fan Cover and lift it off - Fig.3)
2.
Remove 4 screws from the Rear Duct Assembly - (Fig.4), and carefully lower it to gain access to
the fan connector plug on the rear wall of the freezer.
3.
Unplug the fan wiring connector.
4.
Pull the plastic fan impeller off the motor
shaft.
5.
The motor is held in place by a plastic
bracket. Release the bracket by unclipping
both side of the plastic moulding with a flat
bladed screwdriver - Fig.5.
When reassembling ensure correct
location of the front and rear rubber
mounting bushes.
Upper Cover
Screws
Fig.3
Screws (4)
Fig.4
Motor
Clip
1 each side
Fig.5
(right hand
clip shown
here)
