Hotpoint Aquarius WD420G, Информация о сервисе

Страница: 8 / 32

8
Drainage Connections
Take care when you remove the drain hose
from the clips on the back of the machine.
All machines are tested with water before they
leave the factory so a small amount of water
may still be in the hose.
Do not remove the hooked end support from
the GREY drainage hose when using any of
the drainage methods detailed below. You
may need to reposition it as required along the
drainage hose.
For drainage into a standard work top sink,
ensure the outlet pipe has a minimum
diameter of 32 mm. If the sink is inset, the front
edge of the basin must be less than
75 mm from the front edge of the worktop, so
that the drain hose will hook securely into the
sink.
Unclip the drainage hose from the back of the
machine and hook over into the sink. Make
sure that the sink is free of any obstructions
and that the sink plug can not fall into the sink,
preventing the water from draining away
freely. Pumped out water may be very hot.
We recommend one of the following drainage
methods:
Stand pipe Fig. 1 1 Make sure that the
standpipe has a
minimum diameter
of 38 mm.
2 Remove the
drainage hose from
the clips on the
back of the
machine.
3 Make sure that the
top of the standpipe
is positioned at
least 500 mm from
the floor (see
Fig.1).
Use the plumbing
indicator line label
on the back of the
machine as a
guide.
4 Place the drainage hose approximately
100 mm into the standpipe.
500 mm
Extending the drainage hose
If the GREY drainage hose is too short, a
longer drainage hose is available from our
Genuine Parts & Accessories Mail Order
Hotline.
WARNING!
The company denies all liability if and when
these warnings are not respected.
The first wash cycle
Once the appliance has been installed and
before you use it for the first time, run a
wash cycle without detergent and no
laundry, setting the 90°C programme
without a pre-wash cycle.
Under Sink
Waste System
Fig.2
Fig.3
1 Cut out the
membrane, bung or
blanking plug (see
Fig. 2).
2 Unclip the drainage
hose from the back
of the machine.
3 Move the hooked
end support along
the drainage hose
as required.
4 Attach the drainage
hose securely to
the under sink
drainage unit, using
a hose clip (see
Fig. 3).
5 Raise the hooked
end support up to at
least 800 mm to
avoid water being
drawn back into the
machine.
cut
off
end
Hose clip