Hotpoint Aquarius WD420G, Информация о сервисе

Страница: 20 / 32

20
Auto Test Setup
An error test programme can be carried out using Hardware Key Part No. C00095669 which is inserted
into the socket at the rear of appliance and connects to the Power Module.
The Hardware Key can be used on Vogue 4 EVO 2 model Washing Machines and Washer Dryers.
TEST SETUP & INDICATIONS
1. Ensure the machine is switched off and remove the serial port cap.
2. Insert Hardware Key into socket at the rear of the machine with the
plastic pin protection tab fully extended. If it has been removed it
should be refitted before use. Refit Tab with latch uppermost.
See Fig. 2.
Switch the machine on and verify model type by observing the LED
colour displayed on the key as indicated below:-
Flashing Red = Slow flashing indicates a good connection of
Hardware Key into the module. Rapid flashing indicates a poor
connection. If this isn’t displayed it will not work.
Constant Blue = EVO 2 model.
3. The selector can be in any position.
4. Press the AUTO TEST button on the Hardware Key. 'Auto Test' will
scroll across the key LCD display and a beep is heard from the key.
If the Programme Selector is motorised it will advance to another
position after a 10 second pause (this is normal).
5. The Test Programme will now commence.
6. If there is a fault on the machine it will be indicated by a fault code in
the Hardware Key LCD display. Refer to Fault Codes section.
7. The fault must be cleared before the appliance or self test will run
again correctly. (See Notes on following page.)
TEST SEQUENCE
a) Fills through main wash valve - approx. 10 seconds.
b) Fills through pre - wash valve - approx. 10 seconds.
c) Fills through hot valve (if fitted) - approx. 10 seconds.
d) Fills through main wash and pre - wash valves together
(fabric conditioner function) to pressure switch level.
e) Tumbles and heats to 30 °C
f)
Drain and spin.
g) Dryer motor and dryer heating element activated.
h) Machine now resets and a beep is heard from the Hardware Key.
i)
Switch off machine and remove the Hardware Key. Replace the
serial port cap and secure with screw if fitted.
continued overleaf ...
Hardware Key shown fitted
Fig. 1
Pin protection Tab
shown fully extended
TAB
Fig. 2
LATCH
BUTTON
LCD AUTO TEST
DISPLAY