12 of 35
Service Manual UK
Indesit
Company
English
6.
Starts resin wash. Between 1 and 2 litres of water flow directly through the resins. (Inlet valve is
on, regeneration valve is off.
7.
Drains.
Note:
Regeneration time is hidden within the cycle so does not affect programme
times.
Low Salt Warning
An Optical sensor is fitted to the salt container where the presence of salt breaks the beam in the
sensor. When the level of salt is below the sensor level, the receiving sensor receives the light beam
from the sending Led. The Low Salt warning lamp is switched on 6 washes after the sensor signals
the module.
The sensor position is not at the bottom of the salt container because of possible false readings
caused by impurities that collect in the bottom of the salt container.
Note: Whenever the low salt warning lamp is on, the dishwasher will not carry out
regeneration.
Low Rinse Aid
A float is fitted into the rinse aid dispenser, when the level of the float is near the bottom of the rinse
aid reservoir the float will trigger a signal to the Control Module to turn on the Low Rinse Aid Warning
Lamp.
Air Break Assembly
Located on the right hand side of the machine.
The Air Break Assembly carries out 3 functions
1.
Stops filling water siphoning back into the mains
water supply.
2.
Vents the Steam from the dishwasher tub.
3.
Diverts 3% of the hard water fill into the tub to
avoid the water being too soft which could
cause excessive foam.
The Air Break also holds the regeneration valve
and the Water fill turbine.
Regeneration
Fill Turbine
Valve
