Hotpoint Ariston FK 89EL .20 X, Руководство по эксплуатации

Страница: 21 / 24

GB
21
F
3. Grip the door on the two outer sides and
close it approximately half way. Pull the
door towards you, lifting it out of its slot (see
diagram). To replace the door, reverse this
sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals are damaged,
please contact your nearest Service Centre (see Assistance). We recommend
that the oven is not used until the seals have been replaced.
Replacing the light bulb
To replace the oven light bulb:
1. Remove the glass cover of the
lamp-holder.
2. Remove the light bulb and replace
it with a similar one: halogen lamp
voltage 230 V, wattage 25 W, cap G 9.
3. Replace the glass cover (see
diagram).
!
Do not touch the light bulb directly with your hands.
! Do not use the oven lamp as/for ambient lighting.
troubleshooting
The “Clock button” and the digits on the
display flash.
Problem Possible cause Solution
The appliance has just been connected to the
electricity mains or there has been a blackout.
Set the clock.
A programmed cooking mode does not
start.
There has been a blackout. Reprogram the cooking mode.
Only the high luminosity “Clock button”
is lit.
The appliance is in standby mode. Press any button to exit standby mode.
The temperature inside the oven is higher
than the suggested value for the selected
mode.
An automatic mode has been selected.
“Hot” appears on the display and
cooking does not start.
Wait for the oven to cool down.
Fan-assisted cooking has been
selected and the food looks burnt.
Positions 1 and 5: the direct heat could cause
temperature-sensitive foods to burn.
We recommend switching dripping pan
positions halfway through cooking.
Glass cover
Lamp
Lamp
Holder
compartment