Hotpoint Ariston BMBT 2022 IF H/HA, Руководство по эксплуатации

Страница: 22 / 72

22
GB
3. Close the handles on either
side of the container and turn
the knob on the lid of the
container all the way to the
CLOSE position. Then turn the
knob anticlockwise to the
VACUUM position
(see figure A).
4. Press the button on the shelf
and place the container in the
central position (see figure B).
5. Lock the container into
position by pulling the button
on the shelf (see figure C) .
6. Activate the Ever Fresh
function by pressing the
relevant button on the control
panel (the Ever Fresh indicator
light will illuminate). It takes
approximately 1 minute for the
system to suck the air out of the
containers. This stage is
accompanied by a noise that is
caused by the normal operation of the Ever Fresh
function.
7. Once the air suction phase has been completed,
the Ever Fresh LED switches off automatically.
8. Unlock the container from its position by pressing
the button on the shelf.
9. Take it out of the refrigerator
and turn the knob clockwise to
the CLOSE position to avoid
accidental opening (see figure
A) . The absence of air inside the
container is indicated by the
valve at the bottom (see figure
D).
10. To open the container, turn
the knob anticlockwise to the
OPEN position (see figure A) :
this will allow air to enter the
container and make it easy to
open. The valve will move
upwards as air enters the
container (see figure E) .
VUOTO
VACUUM
C
H
IU
S
O
C
L
O
S
E
A
P
E
R
T
O
O
P
E
N
A
2
1
B
C
E
D
! The lid of the container is provided with a circular
valve. When the valve is low (figure D) there is no air
inside the container. When the valve is high (figure E)
air is present inside the container.
! If, after you have created a vacuum (instructions
1-9), the valve moves upward (see figure E) within
three days, check the lid has been put on the
container properly and/or that the container is intact.
Check the storage status of the food before repeating
the vacuum storage operation.
! If the system does not work as it should or if the
pump remains in operation for greater amount of time
than is normal, the Ever Fresh function is deactivated
and the Ever Fresh LED begins to flash. Malfunction is
also signalled by an alarm buzzer.
To exit the alarm status and restore normal operation
of the EVER FRESH function, after checking the status
of the system and the position of the containers, press
the corresponding button on the display to switch off
the Ever Fresh LED. It will now be possible to
reactivate the function. The Ever Fresh function is
deactivated when the refrigerator compartment is
OFF.
Using Ever Fresh to its full potential
The following information is a guide on how to get the
best from the Ever Fresh system and the food it stores.
Ever Fresh containers
• Do not clean the lids in a dishwasher.
• The maximum fill level marked on the container must
be respected when storing liquids of any kind.
Vacuuming actual liquid from the container may
damage the Ever Fresh pump.
• Repeated opening of the vacuumed containers may
disturb the storage conditions of the food inside.
• Before using the system, make sure there is no
visible damage on any part of the container.
• The container valve has a built-in security system. If,
after you have created a vacuum, the valve moves
upward within three days, check the lid has been put
on the container properly and/or that the container is
intact. Check the storage status of the food before
repeating the vacuum storage operation. See
Activating and deactivating Ever Fresh .
• The containers were designed to come into direct
contact with food.
• Do not use the containers for any type of cooking (in
the microwave or oven, on an electric plate, over a
flame, etc.).
• Do not put the containers in the freezer.