18 of 24
Service Manual UK
Indesit
Company
English
P. Motor
1.
Remove the right hand side panel as in (E).
2.
Remove the heater cover - 8 screws.
3.
Remove the 2 fans from the motor hub - 3 hex head screws.
Note: The inner and outer fans are DIFFERENT.
Ensure fans are reassembled in the correct order.
4.
Note the wiring connections and disconnect the motor at the in-line connector and the capacitor.
5.
Disengage the drive belt from the motor shaft as in (M2).
6.
Remove the 2 screws securing the motor and cradle to the base panel.
Note: When refitting the heater cover ensure that the heater wiring is not trapped between the
heater cover and rear panel.
Q. Rear Seal
1.
Remove the drum as in (O).
2.
Remove the rear seal and clean any remnants of the seal and adhesive from the inner face of the
inner back panel.
R. Heating Assembly, Thermistor & Thermostats
1.
Remove the right hand side panel as in (E).
2.
Disconnect the wiring to the heater assembly (multi-pin connector).
3.
Remove the bearing cover.
4.
Remove the 8 screws securing the heater assembly to the rear panel.
5.
Remove the 2 screws retaining the element and thermostats to the heater cover.
If replacing the thermostats both the cycling and one-shot thermostat
MUST
be replaced should either
fail.
NOTE: - When refitting the heater cover, ensure the heater wiring Is not trapped between the
inner and outer rear panels.
Raised
Recessed Hub
Fan Orientation
Hub
Inner
Outer
Inner
Outer
