9
HOW TO MOVE AND LEVEL THE EXERCISE
CYCLE
Before moving the exercise cycle, make sure
that the power cord is unplugged.
Note: If a
CATV cable is connected to the exercise cycle, it
may be necessary to disconnect the cable if the
exercise cycle will be moved far.
Due to the size and weight of the exercise cycle,
moving it requires two persons.
While one person
lifts the indicated end, firmly hold the handlebar and
tip the exercise cycle forward until it rolls on the front
wheels. Carefully move the exercise cycle to the
desired location and then lower it to the level posi-
tion.
CAUTION: To reduce the risk of injury, use
extreme caution while moving the exercise
cycle. Do not attempt to move the exercise cycle
over uneven surfaces.
If the exercise cycle rocks slightly during use, turn
the leveling feet under the front and rear of the
frame until the rocking motion is eliminated.
HOW TO ADJUST THE SEAT
To adjust the seat, pull the adjustment latch, slide
the seat forward or backward to the desired position,
and then release the adjustment latch.
HOW TO PLUG IN THE POWER CORD
If the exercise cycle has a Basic console, it can be
used with or without the included power cord. If the
exercise cycle has a Workout TV console, the power
cord must be used for the TV to be operated.
To use the power cord, first plug one end of the
power cord into the jack on the front of the exercise
cycle. Plug the other end of the power cord into an
appropriate outlet that is properly installed in accor-
dance with all local codes and ordinances.
Adjustment Latch
Lift
Here
Lift
Here
Wheels
Handlebar
Power Cord
Jack
Leveling
Feet
HOW TO SET UP THE EXERCISE CYCLE
