
Set Up / Cleaning Procedures
The Aridex Upholstery Extraction Cleaning
Power cord.
The machine is supplied with
System offers an attractive alternative to outdated
a 30-foot (9m) power cord. The cord is
wet upholstery cleaning systems. With it, no liquid
attached to the center of the front panel. The
touches the fabric, just a soft, gentle dry foam that
cord can be conveniently stored by wrapping
separates the dirt from the fabric, then is removed
tightly around upper half of the hood.
immediately.
Fill the detergent tank.
Unscrew the
The odorless detergent used in this process is
detergent tank cap on the top of the power
actually beneficial to fabrics. No dirt attracting soaps
unit hood. Using the filling funnel, pour no
or toxic dry cleaning fluids are used, and furniture is
more than two U.S. gallons (7.6 liters) of
ready for use immediately after cleaning.
diluted detergent into the tank. The tank is
full when detergent reaches the bottom of
Brushes
the filler tube.
DO NOT OVER-FILL.
Replace
the cap tightly to insure proper foam
Take care to keep foreign objects from
generation.
contacting the brushes while storing or transporting
the machine. Failure to protect the brushes may
Add Liquidator solution to recovery tank.
result in the bristles taking a distorted set.
1) Remove hood - using a screwdriver,
loosen the two retaining screws and lift up.
2) Remove filter housing - unlatch filter
Preparation and Setup
housing and pull straight back.
3) Mix defoamer solution by adding 1 teaspoon
Insert foam connector.
The foam connector
of liquidator concentrate along with 1/4 cup of
goes into the panel on the front of the power
water into the recovery tank.
unit. Take care to align the electrical
4) Replace filter housing and hood.
connections on this unit. Lift the connector
and it will lock in place with a soft “snap”. To
Controls.
On the top of the power unit
remove connector, lift the U-shaped latch
is the main power switch. Make sure
located on the top of the panel and pull out
that the brush unit switch is OFF before
the connector. The following figure shows the
activating the main power switch. The
panel with all connections inserted.
vacuum, foam, and brushes are remotely
controlled by the switch on the brush unit.
Insert vacuum hose coupling.
Insert the
You may use the vacuum when the brush
vacuum hose in the panel.
unit is in either the OFF or ON position.
5
Содержание ARIDEX
