Host ARIDEX, Руководство пользователя, Страница: 20 / 48

Cleaning The Vacuum Hose Removing The Brush Unit
Remove hose from machine To remove the cleaning brushes:
Allow hose to dry thoroughly Pull the inner brush off the center shaft
Tap along sides of hose to loosen dirt Pull the outer brush evenly from the
three drive lugs.
Shake out dirt and debris
Reassamble by replacing the outer brushes
Rinse thoroughly with clear water first, then the inner brushes
Allow to dry, then replace on machine NOTE: Take care to keep foreign objects
DO NOT run motor to dry hose from contacting the brushes while storing or
transporting the machine. Failure to protect
Cleaning the foam generator the brushes may result in the bristles taking
a distorted set.
Using supplied tool, remove foam generator.
Cleaning The Air Intake Screen
Do not disassemble foam generator.
Keeping the intake screen clean allows the motor to
Rinse with warm water run cooler and more efficiently.
Screw Foam Generator back into panel using To clean the screen:
supplied tool.
Empty the detergent and recovery tanks
NOTE : Spare foam generator is located
in supplied tool. Turn the unit on it's side
Looking up from the bottom of the machine,
the screen is located in the middle of the
detergent tank.
Using the supplied brush, or vacuum, gently
clean the screen being careful not to push too
hard on the screen.
Cleaning the Check Valve
Remove air hose from control panel
Unscrew Check Valve from panel
Do not disassemble check valve
Rinse Check Valve in warm water
Screw Check Valve back into panel
NOTE: Take care to not cross thread
Reattach air hose to control panel
17