Hospira LifeCare XL Series, Техническое и сервисное руководство

Страница: 76 / 278

6.2 ALARM MESSAGES AND ERROR CODES
Technical Service Manual 6 - 13 430-00587-008 (Rev. 2/05)
6.2.3.4.1
Communication Selection
The value of the communication selection can be either 0 or 1. Value 0 means that the
communication circuitry of the infusion system will be powered up when the device
is operating on AC (mains) power, and will be powered down when the infusion system
is operating on battery. Value 1 means the communication circuitry will be powered up
regardless of the power supply type.
Table 6-5, Communication Circuitry Selections , shows
how the communication selection and the power supply determine the power of the
communication circuitry. Use the [
S
] and [
T
] keys to toggle the value between 0 and 1.
6.2.3.4.2
Soft ID
The large digits indicate the current value of the soft ID. The range is between 0 and 9999.
Use the [
S
] and [
T
] keys to change the value. The [
S
] key increases the value up to,
but does not exceed, 9999. The [
T
] key decreases the value down to, but does not pass, 0.
6.2.3.4.3
Channel Label
The first two of the large digits indicate the current hard ID if the setting of the junction
box has no parity error. If there is no entry, two dashes will be displayed. The third digit
displays a dash. The fourth digit indicates the current value of the channel label.
The fourth digit should be 0 for the single channel version of the infusion system
(i.e., XLM with DataPort).
Simultaneously press and hold the [TITRATE/QUICKSET] and [SILENCE] keys for two
seconds to change the value. Use the [
S
] key to increase the value and [
T
] key to decrease
the value.
Table 6-5. Communication Circuitry Selections
Selection AC Operation Battery Operation
0 Power up communication circuitry Power down communication circuitry
1 Power up communication circuitry Power up communication circuitry