2. Sanitizing Procedure - Following Cleaning Procedure
1) Dilute 2 fl. oz. (60 ml or 4 tbs) of a 5.25% sodium hypochlorite solution (chlorine bleach)
with 4 gal. (15 l) of warm water.
2) Remove the insulation panel if it is in its normal position.
3) Pour the sanitizing solution into the water tank.
4) Move the service switch to the "WASH" position.
5) Replace the insulation panel and the front panel in their correct positions.
6) Turn on the power supply to start the sanitizing process.
7) Turn off the power supply after 15 minutes. Remove the front panel.
8) Move the service switch to the "DRAIN" position.
9) Replace the front panel and turn on the power supply for 2 minutes.
10) Turn off the power supply. Remove the front panel.
11) Repeat steps 17 through 29 in "1. Cleaning Procedure" two times to rinse thoroughly.
12) Repeat steps 1 through 11 above one more time.
13) Move the control switch to the "ICE" position.
14) Replace the front panel in its correct position.
15) Clean the dispenser unit/storage bin liner using a neutral cleaner. Rinse thoroughly
after cleaning.
16) Turn on the power supply to start the automatic icemaking process.
B. Maintenance
IMPORTANT
This icemaker must be maintained individually, referring to the instruction
manual and labels provided with the icemaker.
1. Stainless Steel Exterior
To prevent corrosion, wipe the exterior occasionally with a clean and soft cloth. Use a
damp cloth containing a neutral cleaner to wipe off oil or dirt build up.
2. Dispenser Unit/Storage Bin and Scoop
•
Wash your hands before removing ice. Use the plastic scoop provided (bin accessory).
•
The dispenser unit/storage bin is for ice use only. Do not store anything else in the
dispenser unit/storage bin.
•
Clean the scoop and the dispenser unit/storage bin liner using a neutral cleaner. Rinse
thoroughly after cleaning.
3. Condenser
Check the condenser once a year, and clean if required by using a brush or vacuum
cleaner. More frequent cleaning may be required depending on location.
