2
[6] Flush button
Functions as a switch to flush the pipes beyond the sanitizing and
cleaning water outlets. Also functions as down button to decrease the
set values.
[7] Flow rate lamp
Indicates the currently selected flow rate.
[8] Flow rate select button
Adjusts the flow rate.
[9] Set/reset button
Only qualified service personnel or installer may press this button to
adjust various set values.
[10] Power switch
Turns the unit on and off.
Note: When the low flow rate is selected, sanitizing water may have
an excessive available chlorine concentration. Select this flow
rate only when the electrolyzed water property is inadequate.
[c] OPERATION PANEL
[1] Error lamp (red)
Indicates that there is trouble detected.
[2] Replace cell lamp (red)
Indicates that the cell life is near completion. Flashes continuously
from 2900 hours to 3000 hours and stays on after 3000 hours.
[3] Flush lamp (red)
Stays on during the flush operation. Indicates that the unit is in flush
cycle.
[4] Add salt water lamp (red)
Indicates that the salt water tank level is too low.
[5] Ready lamp (green)
Flashes until the desired settings are achieved and stays on when the
unit is dispensing electrolyzed water.
[6] Operation lamp (green)
Indicates that the unit is running.
[7] Dispense button
Starts and stops dispensing electrolyzed water.
[d] REMOTE CONTROLLER
[1] Continuous dispense lamp (green)
Lights in the continuous dispensing mode which is activated or
disactivated by pressing the dispense button or putting a hand or
object in front of the dispensing sensor on the left.
[2] Dispense button
Starts and stops dispensing electrolyzed water in the continuous or
portion control dispensing mode.
[3] Electrolyzed water lamp (green, orange)
Indicates the cleaning water and sanitizing water outlets.
[4] Dispensing sensor
Senses a hand or object to start and stop dispensing electrolyzed
water without using the dispense button.
[5] Electrolyzed water outlet
Discharges electrolyzed water.
[6] Add salt water lamp (red)
Indicates that the salt water tank level is too low. Flashes when the
error lamp on the operation panel lights up.
[7] Ready lamp (green)
Flashes until the desired settings are achieved and stays on when the
unit is dispensing electrolyzed water.
[8] Handwash button
Starts and stops dispensing electrolyzed water in the handwash
mode.
[9] Handwash lamp (green)
Lights in the handwash mode which is activated or disactivated by
pressing the handwash button or putting a hand or object in front of
the dispensing sensor on the right. The electrolyzed water lamps light
up in turn to indicate the proper handwashing steps - first cleaning,
then sanitizing (adjustable from 15 to 120 seconds each).
[10] Portion control lamp (green)
Lights in the portion control dispensing mode which is activated by
pressing the dispense button for 3 seconds or putting a hand or object
in front of the dispensing sensor on the left for 3 seconds. Water
automatically stops after the set dispense time indicated in the display
on the control panel (adjustable from 1 to 60 minutes).
Note: To avoid unbalancing the water properties or causing water
leaks, do not block the water outlets.
The dispensing sensor may react with reflective materials such
as glass and metal, even outside the normal detection range.
[e] ACCESSORIES
Connector
pH test paper UNIV Chlorine test paper
Instruction manual
Installation manual
Operation sheet
Cap
Gasket
Pressure reducing valve
Water supply hose
Braided hose
Measuring cup
Salt water tank
Clamp
Rubber dropper
XM Connector (5P)* Dual check valve
Nipple
[1] [2] [3] [4] [5] [6] [7]
[1]
[2]
[3]
[4]
[5]
[10]
[9]
[8]
[7]
[6]
* To operate the unit in the pool mode, replace the XM
connector (5P) [red] on the rear of the control box
with the accessory XM connector (5P) [blue]. See “II. 9.
[a] OPERATION MODE” in the installation manual.
2. CHECKS BEFORE OPERATION
[a] CHECKING AMOUNT OF REMAINING SALT WATER
1) Check that there is enough salt water in the salt water tank.
2) Add salt water according to “[b] SUPPLYING SALT WATER” if there
is not enough or no salt water in the tank.
