Hoshizaki KM-280MAH, Инструкция по эксплуатации

Страница: 14 / 23

14
Base Cover
8. START UP
IMPORTANT
1. All parts are factory-adjusted. Improper adjustments may result in failure.
2. If the unit is turned off, wait for at least 3 minutes before restarting the
icemaker to prevent damage to the Compressor.
3. Do not operate the unit in the “WASH” position without water in the Water
Tank. This will cause damage to the Water Pump seal.
1) Open the Water Supply Line Shut-off Valve. See Fig. 4.
2) Remove the Front Panel by removing the screw at the bottom of the panel, swinging the
panel out and lifting it up.
3) Move the Control Switch, on the Control Box,
to the “ICE” position.
4) Replace the Front Panel in its correct
position.
5) Turn on the power supply, and allow the
Water Tank to fill with water and the
icemaker to operate for a total of 10
minutes.
6) Remove the Front Panel and the Base
Cover and turn the control switch to “OFF”.
See Fig. 5.
Fig. 5
7) Check to assure that the Bin Switch shuts the unit down.
a) Turn the control switch to “ICE”.
b) Allow the unit to cycle into the freeze mode. This occurs when the
pump motor starts to supply water upwards, through the supply tube.
After 1-2 minutes in freeze, move the bin switch paddle fully to the right
See Fig. 6.
c) The unit should shut down within 3-5 seconds.
Note: The Bin Switch will only shut down the unit at the end of a harvest or within the first
5 minutes of the freeze cycle. To shut the unit down outside of this time period
turn the control switch to “OFF”.