Hoshizaki FTC-120MDA, Руководство по обслуживанию

Страница: 47 / 53

44
[c] CONDENSER
1) Pull out the condenser according to steps 1) through 3) of “[b] COMPRESSOR”.
2) Remove the screws securing the shroud to the condenser, and disconnect the shroud.
3) Disconnect the condenser from the refrigeration circuit using brazing equipment. Use a
wet towel to protect any flammable materials from burner flame.
4) To replace the removed parts, reverse the above removal procedure.
Note: See Notes 1 - 5 for “[b] COMPRESSOR”.
[d] DRIER
1) Pull out the condenser according to steps 1) through 3) of “[b] COMPRESSOR”.
2) Remove the wire tie securing the drier to the shroud.
3) Disconnect the drier from the refrigeration circuit using brazing equipment. Use a wet
towel to protect any flammable materials from burner flame.
4) To replace the removed parts, reverse the above removal procedure.
Note: 1. See Notes 1 - 5 for “[b] COMPRESSOR”.
2. After brazing, wait for the drier to cool down before securing it to the shroud.
[e] EVAPORATOR
1) Remove the front panel.
2) Unscrew the top and bottom of the control box to remove the control box.
3) Remove the unit side panel.
4) Recover the refrigerant from the access valve, and store it in a proper container, if
required by an applicable law.
5) Disconnect the evaporator from the heat exchanger (first from the suction pipe and
then from the capillary tube) using brazing equipment. Use a wet towel to protect any
flammable materials from burner flame.
6) Remove the intake and exhaust ducts from inside the cabinet.
7) Remove the interior fan motor assembly.