Hoshizaki FM-170EE-50-HC, Руководство по обслуживанию

Страница: 22 / 46

19
Fig. 6 Fig. 7
Water Supply Tap
Inlet Hose
5. WATER SUPPLY AND DRAIN CONNECTIONS
* The connections to the mains water supply must be made in accordance with the
countries’ current requirements of the Water Supply or Water Fittings Regulations.
* Only potable water should be used for the icemaker.
* Water supply pressure should be minimum 0.5 bar and maximum 8 bar. If the pressure
exceeds 8 bar, use a proper pressure reducing valve. Do NOT throttle back the supply
tap.
* A plumbing permit and services of a licensed plumber may be required in some areas.
* The icemaker drain is gravity flow, so ensure drain pipe has an adequate pitch or fall.
* Water should drain into an open trap.
1) Attach angled end of white flexible inlet hose (accessory) to the G3/4 fitting at the
top rear of the icemaker as indicated, ensuring rubber sealing washer is correctly
positioned. Hand tighten sufficiently to provide leak free joint.
2) Attach the other end of inlet hose to the water tap, noting washer is correctly
positioned before hand tightening as above.
3) Attach grey flexible outlet hose (accessory) to the R3/4 fitting at the bottom rear of
the icemaker as indicated, confirming fitment of rubber washer before finally hand
tightening the joint. This pipe can be cut to length as necessary to suit position of main
drain.
Water Supply
Inlet G3/4
Inlet Hose
Drain Outlet
R3/4
Outlet Hose