ENGLISH
3
5. This appliance is not suitable for installation
in an area where a water jet could be used
and where dripping is not allowed.
6. Do not place anything on top of the
icemaker or in front of the louver.
3. INSTALLATION
* Incorrect installation can cause harm to people,
animals or things, for which the manufacturer
cannot be held responsible.
[a] STORAGE BIN
1) Fully screw in the four legs provided (bin
accessory) into the storage bin underside. See
Fig. 3.
2) Position the storage bin in the selected
permanent site.
3) Remove the tape from the chute opening at the
bottom of the icemaker.
Fig. 7
Adjust legs
Bottom Plate
Adjustable Legs
Fig. 3
Fig. 6
Icemaker
Mounting
Bracket
Bin
Bolt
4) Pull down the end of the string coming out of the
chute opening to remove the cushion.
Note: If the power supply is turned on with the
cushion left inside, the icemaker will not start
showing “BIN FULL” in the display.
5) Place the icemaker on top of the storage bin by
holding the bottom.
6) Secure the icemaker to the storage bin, by
using the two mounting brackets and two bolts
provided. See Fig. 6.
7) Seal the seam between the
icemaker and the storage bin
with food grade sealant.
8) Refit the side panels in their
correct position.
9) Adjust the four legs on the
bottom (adjustable from 0 to
25.4 mm) to have the icemaker
perfectly horizontal. Use the
spirit level. See Fig. 7.
[b] REFRIGERANT SYSTEM
Use an appropriate condensing unit based on:
FM-600ALKE-CO2(N)-SB
Refrigerant: R744
Supply pressure: 4 MPa (40 bar) or less
Refrigeration duty: 1.41kW at -25°C
FM-1200ALKE-CO2(N)-SB
Refrigerant: R744
Supply pressure: 4 MPa (40 bar) or less
Refrigeration duty: 2.82kW at -25°C
Tape
Fig. 4
Fig. 5
String
