92E2DA20E0303
ENGLISH
2
7) Adjust the four legs on the bottom (adjustable from
0 to 25.4 mm) to have the icemaker perfectly
horizontal. Use the spirit level. See Fig. 4.
4. ELECTRICAL CONNECTIONS
WARNING
THIS APPLIANCE MUST BE EARTHED
This icemaker requires an earth that meets the
national and local electrical code requirements.
To prevent possible severe electrical shock to
individuals or extensive damage to equipment,
install a proper earth wire to the icemaker.
* This icemaker must have a separate power supply
or receptacle of 3N~400V (Three-phase star, four-
wire; earthed neutral).
* When the power supply cord is connected, it must
have a capacity of not less than 10A.
* The fixed wiring must incorporate a means for
disconnection from the supply having a contact
separation of at least 3 mm in all poles.
* Usually an electrical permit and services of a licensed
electrician are required.
* If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent of a similarly
qualified person in order to avoid a hazard.
* In accordance with the requirement of the IEC
standard, the maximum permissible system
impedance (Zmax) at the interface point of the power
supply to be connected with this icemaker must be
0.0225+j0.0225 ohm. Determine in consultation with
the supply authority, if necessary, that the icemaker
is connected only to a supply of 0.0225+j0.0225
ohm or less.
Fig. 3
Fig. 2
Fig. 4
Bottom Plate
Adjustable Legs
Adjust legs
and/or service should they be required. Allow
60 cm clearance on top to allow for removal of
the Auger.
5. This appliance is not suitable for installation
in an area where a water jet could be used
and where dripping is not allowed.
6. Do not place anything on top of the icemaker
or in front of the Louver.
3. INSTALLATION
* Incorrect installation can cause harm to people,
animals or things, for which the manufacturer cannot
be held responsible.
1) Fully screw in the four legs provided (bin accessory)
into the Storage Bin underside. See Fig. 2.
Icemaker
Bolt
Bin
Mounting
Bracket
2) Position the Storage Bin in the selected permanent
site.
3) Place the icemaker on top of the Storage Bin by
holding the bottom.
4) Secure the icemaker to the Storage Bin, by using
the two mounting brackets and two bolts provided.
See Fig. 3.
5) Seal the seam between the icemaker and the
Storage Bin with food grade sealant.
6) Refit the Side Panels in their correct position.
