13
ENGLISH
Above 300 μS/cm:
Excessive ice may build up on evaporator and freeze beer inside beer coil preventing beer from being dispensed properly.
How to make cooling water with 100-300 μS/cm of E.C.
The capacity of the water tank of this unit is approx. 30 L.
Make the cooling water by dissolving 5 g of pure baking soda in approx. 10 L of distilled water,
and then add approx. 27 L of distilled water to fill the water tank.
Step 1
Measure 5 g of pure baking soda with nozzle cap (accessory).
Step 2
Fill a bucket with approx. 10 L of distilled water and stir well after adding the 5 g of baking
soda measured in step 1.
Rinse the nozzle cap after use.
[b] COOLING WATER SUPPLY
WARNING
Before filling the water tank, turn off the power switch (earth leakage breaker) and unplug the unit.
NOTICE
Do not splash water on the electrical parts.
Do not fill the water tank above the water level line, or the drain pan will overflow and spill water.
1) Remove the top cover.
2) Pour the bucket (approx. 10 L) of cooling water prepared.
3) Fill the water tank up with approx. 27 L of distilled water to the water level line marked inside
the water tank.
4) Use a conductivity meter if measuring the electric conductivity.
5) Close the top cover.
3. CHECKS BEFORE OPERATION (DAILY)
[a] CHECKING CO2 GAS CYLINDER
Open the main valve of the CO2 gas cylinder, and check the gas
pressure by the level gauge of the regulator:
* If the level gauge reading is not more than 3 MPa or falls into the
yellow zone, the cylinder contains little CO2 gas.
* If the level gauge reading is not more than 1 MPa or falls into the
red zone, replace with a new cylinder.
[b] REPLACING CO2 GAS CYLINDER
1) Close the main valve of the CO2 gas cylinder by turning it clockwise.
2) Turn the regulator adjust dial to set the pressure to “0” (MPa).
3) Use the spanner (accessory) to loosen the nut and remove the regulator from the CO2 gas
cylinder.
Note: Be sure to cap the CO2 gas cylinder.
4) Open the main valve of the new CO2 gas cylinder for a second to blow dirt and dust off the
joint (together with CO2 gas).
Level Gauge
Nut
Main Valve
Regulator
Adjust Dial
Gasket
CO2 Gas Cylinder
* The regulator design is different
for each beer company.
Cap
Distilled Water
(approx. 10 L)
Bucket
Nozzle Cap 5/6
(5 g)
Nozzle Cap
Water Tank
中文：478537L01
