MAN1138-03-EN
-EU
Unit 1 Centrepoint, Centre Park Road, Cork, T12 H24E, Ireland. | (p) +353 21 4321 266 (f) +353 021 4321 826 | www.horner-apg.com
g.com
g.com
g.com
g.com
g.com
g.com
Please visit our website for a complete listing and to learn more about certified Horner Automation products.
This document is the property of Horner Automation Group, and is subject to change.
page 7 of 7
8.1 - WARNINGS
1.
To avoid the risk of electric shock or burns, always connect the safety (or earth) ground
before making any other connections.
2.
To reduce the risk of fire, electrical shock, or physical injury, it is strongly recommended to
fuse the voltage measurement inputs. Be sure to locate fuses as close to the source
as possible.
3. Replace fuse with the same type and rating to provide protection against risk of fire and
shock hazards.
4.
In the event of repeated failure, do NOT replace the fuse again as repeated failure indicates
a defective condition that will NOT clear by replacing the fuse.
5.
Only qualified electrical personnel familiar with the construction and operation of this
equipment and the hazards involved should install, adjust, operate, or service this equipment.
Read and understand this manual and other applicable manuals in their entirety before
proceeding. Failure to observe this precaution could result in severe bodily injury or loss
of life.
6. If the equipment is used in a manner not specified by Horner APG, the protection
provided by the equipment may be impared.
8.2 - FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1.
This device may not cause harmful interference
2.
This device must accept any interference received, including interference that may
cause undesired operation
8.3 - PRECAUTIONS
All applicable codes and standards need to be followed in the installation of this product.
Adhere to the following safety precautions whenever any type of connection is made to the
module:
1.
Connect the safety (earth) ground on the power connector first before making any
other connections.
2.
When connecting to the electric circuits or pulse-initiating equipment, open their
related breakers.
3.
Do NOT make connection to live power lines.
4.
Make connections to the module first; then connect to the circuit to be monitored.
5.
Route power wires in a save manner in accordance with good practice and local
codes.
6.
Wear proper personal protective equipment including safety glasses and insulated gloves
when making connections to power circuits.
7.
Ensure hands, shoes, and floor are dry before making any connection to a power line.
8.
Make sure the unit is turned OFF before making connection to terminals.
9.
Make sure all circuits are de-energized before making connections.
10.
Before each use, inspect all cables for breaks or cracks in the insulation. Replace
immediately if defective.
11.
Use copper conductors in Field Wiring only, 60/75
˚
C.
8 SAFETY
9 PART NUMBER
GLOBAL MODEL NUMBERS
HE-X4
R
relay and solid state outputs
A
solid state output
model
10 CONTACT INFORMATION
For assistance and manual updates, contact Technical Support at the
following locations:
North America
Europe
(317) 916-4274
(+) 353-21-4321-266
9.1 - Part Number Builder
10.1 - Technical Support
