It is possible but not recommended that a locomotive that is not fitted with a decoder (analogue) can be operated
on a digital layout.This locomotive is given the address “0”.
Running an Analogue Locomotive:
1.
Press
on the keypad. Press “SELECT” to confirm. The LCD will display 00.
2.
Turn the Control Knob clockwise to move the locomotive.
Pressing the
or
buttons on the keypad controls the direction of the locomotive.
The acceleration and deceleration of the locomotive is controlled via the Control Knob only.
0
Please Note:
If a digital locomotive is called up for operation the analogue locomotive will continue to run at the speed
set prior to the digital locomotive being operated.
It is not possible to program into the analogue locomotive acceleration or deceleration levels.
When an analogue locomotive is placed on the track it will emit a high pitched noise when stationary,
which will become louder when running, this is normal.
Only one analogue locomotive (No. 0) can be run on a digital layout at anyone time.
17
Analogue Locomotive Control
For more information visit:
www.hornby.com
16
The
Hornby Select Digital Control
unit is capable of remotely switching on and off up to 9 functions which
may be incorporated in to some locomotives. For example the locomotive may be fitted with lights, engine running
sounds and a horn or whistle. Using the
Select
each function can be switched on or off.
If the locomotive has only one function (normally lights) then a “fast toggle” can be used.
Fast Toggle:
1.
Enter the address of the locomotive you wish to control and press “SELECT” to confirm. The LCD display
will flash the locomotive address.
2.
Press the “FUNCTION” button.The LCD display will flash “F0”, and the lights will go off.
3.
Press the “FUNCTION“ button again to turn the lights on.
Controlling Locomotive Functions:
For locomotives that have more than one function it is important that each function is noted and can be referred
to by a number.
For example Lights = 0, bell = 1, horn or whistle = 2 etc.
To switch the functions On or Off the following procedure should be followed: In this example the horn will be
switched on.
1.
Enter the address of the locomotive you wish to control, and then press the Select button. The LCD will
display the locomotive address.
2.
Press and hold “FUNCTION” +
for one second. The LCD display will flash “F2” and the horn will
be activated.
3.
To turn the horn off, press and hold “FUNCTION” +
again.
2
2
Locomotive Function Control
Please Note:
The lights can also be turned on and off by pressing Fu
0
