For more information visit:
www.hornby.com
22
Programming Track
When addressing locomotives and Hornby Point/Accessory Decoders it is important that all other locomotives
are removed from the track. It is also important that all point decoders are disconnected from the layout.
This can become rather difficult at times, therefore it is suggested that a Programming Track is used for the
allocation of addresses. A Programming Track is a length of track electrically isolated from the main circuit but
includes one Hornby R8206 Power Track and an R046 lever switch. To initiate the Programming Track, (see
diagram below) use the Lever switch to connect or disconnect from the track layout.
To programme a locomotive follow the instructions on Page 7.
In respect of R8216 Point/Accessory Decoders it is not necessary for them to be in position and connected to
their respective point motors for them to be programmed. It is much easier if they are programmed on the
Programming Track.This is simply done by connecting the R8216 Point/Accessory Decoder to the track, (using
the R602 Power Clip) supplied with the unit this will allow for the programming to be carried out as described
on Page 25.
23
The four function R8215
Hornby Digital Decoder
features:
Load compensation (Back EMF):
Locomotive will run at a consistent speed either on the “flat” or on
gradients.
Selectable for operation with 14, 28 or 128 speed steps:
The greater the number of speed steps the
smoother the acceleration. All Hornby decoders are factory set at 128 steps.
Four On/Off function outputs:
Two of the function outputs are dedicated for the direction of lights-front
and rear.
Analogue operation:
Locomotives fitted with a
Hornby Digital Decoder
can be operated on an analogue
system but without the benefits of digital control.
Overload cut-out:
The
Hornby Digital Decoder
is rated at a 500mA continuous current and 1Amp for a
short period. Should this be exceeded then the decoder will overload and cut out.This action protects not only
damage to the decoder but also the locomotive.
Dimensions: 17mm x 10mm x 3.5mm
Hornby Digital Decoder
