5
EN
LVC is a feature built into your ESC to protect the
battery from over-discharge. When the battery
charge becomes too low, LVC limits power supplied
to the motor. When you hear the motor power pulse,
land the aircraft immediately and recharge the fl ight
battery.
NOTICE:
Do not rely on LVC to determine when
to land your aircraft. Set a fl ight timer to the
recommended fl ight time. Repeated fl ying to LVC
will damage the battery.
Low Voltage Cutoff (LVC)
IMPORTANT:
After you set up your model,
always rebind the transmitter and receiver
to set the desired failsafe positions.
Program Your Transmitter
1. Start with a clean model memory slot.
2. Set the model type to “Airplane.”
3. Leave all settings at their default values.
Switch A will now control the fl ight mode
function.
• Switch position 0 = SAFE Mode
• Switch position 1 = AS3X Mode
Computerized Transmitter Setup
(DX6e, DX6 G2, DX7 G2, DX8 G2, DX9, DX18 and DX20)
Start all transmitter programming with a blank ACRO model
(do a model reset), then name the model.
Set Servo Travel to:
100%
F-Mode Setup
Switch 1
Inhibit
Switch 2
Inhibit
Channel Assign
Channel Input Confi g
1 Throttle
2 Aileron
3 Elevator
4 Rudder
5 Gear
Switch A
6 Aux 1
Frame Rate
22mz
DSMX
Funtion List
Timer
Mode
Count Down
Time
6:00
Start
Throttle Out
Over
25%
One Time
Inhibit
Transmitter Setup
