Mini AeroScout
EN
7
Binding
Install the Flight Battery
1. Apply the soft, loop side of the hook and loop tape to the
battery tray inside the fuselage.
2. Apply the hook side to the battery.
TIP:
Do not cover the battery label information with the hook
material.
3. Install the battery in the fuselage. Move the battery forward
or backward in the fuselage to adjust the aircraft center of
gravity. The center of gravity should be 39-44mm back from
the leading edge of the wing, as shown in the illustration.
TIP:
Install the 1S 800mAh battery towards the front of the
battery compartment to achieve the correct CG.
Arm the Aircraft
CAUTION:
Always keep hands away from the
propeller. When armed, the motor will turn the
propeller in response to any throttle movement.
1. Ensure the transmitter throttle stick is in the lowest position.
The motor will not arm if the throttle is not set to the lowest
position when powering on the aircraft.
2. Power on the transmitter.
3. Connect a fully charged fl ight battery.
4. The motor will be armed when the battery is connected.
Binding is the process of programming the receiver to
recognize the GUID (Globally Unique Identifi er) code of a single
specifi c transmitter. The transmitter and receiver are bound at
the factory. If you need to rebind, follow the instructions below.
1. Ensure the transmitter throttle stick is in the lowest position.
2. Install and connect a fully charged fl ight battery to the
aircraft.
3. After approximately 5 seconds, the LED on the aircraft
fl ight control board will begin to fl ash rapidly.
4. Push and hold down the left transmitter stick.
5. Power on the transmitter. Release the left stick when the
transmitter beeps.
6. The LED on the aircraft fl ight control board will glow solid
when binding is complete.
CAUTION:
Always keep hands away from the
propeller. When armed, the motor will turn the
propeller in response to any throttle movement.
39-44mm
